The strangest thing is though, If I go to the other router which is connected to the technicolor router via an ethernet cable, and has DHCP, UPNP etc turned off and a static IP within the same range (192.168.1.252) (which is purely used as a wireless access point, and has been working like this for months), this too cannot see the internet via I have a Technicolor router/modem from Cox ISP. I have 2 ADT security devices connected to it and one Nest WiFi system. I have reserved the IP addresses for the 3 devices connected within the menu of the Technicolor by MAC address. I then shut off DHCP on the technicolor. The Technicolor administrative portal allows you to configure the settings of your Gateway. To access the administrative portal, use a computer or device that is connected to your Gateway. Note: If you want to enable remote access to securely access your gateway, see Setting Remote Access in the Technicolor CGA4131 or CGA4332 Administrative Portal. Technicolor Router: Setup. A step-by-step tutorial video on how to install the Technicolor Router for Internet from Batelco on your PC.Also watch Technicolor Router: Wireless Settingsh It is recommended that you turn off the gateway first, then disconnect or unplug any existing Ethernet cable plugged into the gateway’s local-area (LAN) port. Plug it into your new router’s WAN port and switch the gateway back on. Wait a moment for it to boot up, before plugging in the router’s power supply. . This is the best method to connect with WPS with TECHNICOLOR router. How to Enable WPS Connection for TECHNICOLOR TC7200v2: Firstly, open TECHNICOLOR TC7200v2 Admin Page, if you don't know how you can check how to open TECHNICOLOR TC7200v2 Admin Page here. Now find on your router the WPS tab which should be in the WLAN configuration section. pass: Access Key found on the Router. if the Router is set to the default firmware: user: admin. pass: blank (empty) Whilst your router is turned on, carefully push a thin object into the reset hole on the rear of the unit until the power light turns off, then release the button. Once the Router has re-started, we will need to access the Router The following guide shows how to manually configure a Technicolor TG588v v2 router to work with an FTTC or ADSL. Page 2 The default username is admin and default password is admin. Once this has been entered you will get the following prompt. It is recommended to use serial number of the router as the new password. Page 3 Click Setup your gateway. Router Quick Start Guide Technicolor DGA4134 Switch router on. Status light will be orange, Broadband light should blink then go steady Plug in the supplied power cable Connect your computers or your network to ports 1-4. Connect DSL port to the phone socket via a splitter (optional) using the supplied 'grey' cable. The router will be sent its Learn how to enable remote assistance on a Technicolour router in this how to guide.Follow us on social: LinkedIn:

how to connect technicolor router